Specifications

SECTION 2 INSTALLATION INSTRUCTIONS

2.1

Unpacking

Unpack the instrument and inspect for shipping damage. Report any

damage to the carrier immediitely.

2.2 Locating

Select a

location

for the controller where it will not be subject to excessive

shock vibration, dirt moisture or oil. The ambient temperature of the area

should be between

32º

and 131

ºF

(A model

DC-15

dust, oil and water

resis-

tant cover is available to protect from harsh environments.)

2.3

Mounting

Mount the controller into a 92 mm (3

5/8”)

square cutout See figure for the

cutout and case dimensions. The plug-in controller does not have to be

removed from its housing for mounting. Remove two screws that hold the

mounting slides and then remove the slides. Insert case from front panel

and

re-install

the two slides and two screws. Do not over-tighten screws. The

length of the slides must be reduced if the controller is to be mounted in an

extra thick

panel.

If the controller has been unplugged from its housing, the

top of the housing can be determined because it features the serial tag.

2.4

Removing

Unit

The 6075 can be removed

from

its housing by pulling firmly on the black

front bezel. If a communication port is connected, it should be removed

first