User's Guide

5900 NW 86
TH
Street • Suite 300 • Johnston, IA 50131 • 515.288.3360 • www.athenagtx.com
2.8 Label and compliance information
A physical label stating “Contains FCC IDs: 2AVRK-XBS6BTH, 2AA9B04” or “Contains FCC IDs: 2AVRK-
XBS6BTH, 2AA9B05” will be used. Note, the label ‘phrase’ will be a single line on the host product.
2.9 Information on test modes and additional testing requirements
Devices shall be reviewed under configured max operational settings (standard use) for SAR, Spurious
Radiated Emissions. Unintentional Radiators is also required for review, however, due to setting
requirements (RF modules disabled), only Athena GTX Inc. is permitted to configure a test unit for this
mode.
When testing for all, except for Unintentional Radiators, Wi-Fi must be tested after a connection with a
partnering WLAN device is established and information is transmitting. Additionally, BLE shall be co-
located, as such, it needs to be paired with a compatible device to allow RF traffic.
Antenna power, duty cycle, and transmission rate cannot be altered from approved settings, see RF
Exposure report for technical information.
2.10 Additional testing, Part 15 Subpart B disclaimer
Not applicable, see this section in original Digi XBee Wi-Fi RF Module User Guide rev W, or greater.