User Manual

TIPS for Analog Operation
1. Turn up the throttle until sounds start and locomotive idles.
2. Select the locomotive’s direction either by the direc
-
tion switch on the power pack or by the transmitter.
3. Slowly start your locomotive moving by using the
power pack’s throttle to set desired top voltage set-
ting.
4. Once underway, use the transmitter Button 4 to speed
up or Button 3 to slow down. Hold down the button
until you reach the desired speed.
5. If the top voltage setting at maximum speed is too low,
use the power packs throttle to adjust the top voltage set
-
ting.
6. To conserve battery, use the throttle to control locomo
-
tive speed and use the transmitter to activate sounds.
7. When finished running your locomotive, turn your power
pack throttle to OFF and turn off the power pack’s power
switch. Any programming changes made in DC analog
mode will affect any prior DCC mode settings
.
3. Slowly turn the throttle until sounds come on. Once
sounds begin you have 20 seconds to enter the program
mode.
4. Enter the program mode by pressing the Button STP three
(3) times. The locomotive will say “programafter each
press. After the third “program,you will be in program
mode.
5. Press Button 4 or Button 3 to speed up or reduce the
chuff rate, respectively. Each press of the button adjusts
the chuff rate up or down by one unit. Each time you will
hear the locomotive say “program”.
6. Press Button W to toggle between volume settings. You
will hear the locomotive say program” with the new
volume setting.
7. Once finished programming, turn the power switch on the
power pack to OFF. This will reset the locomotive and
lock in your programming. To resume operation, follow
the steps under “DC Operation”.
Manual Volume Control
Located on the top of the tender towards the rear,
there are 3 oval hatches. Remove the middle hatch and
use a small flat-bladed jeweler’s screwdriver to adjust the
volume.
Remove this hatch to adjust sound