Instructions / Assembly

loh ngilA
saf
This
of the ces by
Assembly Instructions
(cont.)
Step 2:
.) EEEE( sgeL dnats fo seloh htiw )A( lwoB eriF fo se
Insert Bolts through holes of Fire Bowl and Legs and attach
with Nuts (Fig 1). Attach all three (3) legs to Fire Bowl and
securely fasten bolts with screwdriver and wrench.
Step 3:
Attach four (4) Outer Ring Sections together by inserting
each end together forming ring as shown (Fig 2). Once as-
sembled, place ring around Fire Bowl and align screw holes
and attach nuts (Fig 3). Hand tighten nuts only until all bolts are
in place. Securely tighten with screwdriver wrench.
Step 4:
Insert screws through underside of ring at each joint in Outer
Ring (Fig. 5). Securely fasten with screwdriver.
Step 5:
Place Screen on the Fire Bowl (Fig 6).
Step 6:
non-combustible surface.
Please read and follow all Warnings and
ety instructions before using.
General Care
short
Warning: This Product can expose you to
chemicals including Benzene, which is known
to the state of California to cause cancer and
birth defects or other reproductive harm.
For more information go to
www.P65warnings.ca.gov
limited warranty is applicable to non-commercial residential use only in the United States.This warranty only applies to the functionality
product, and does not cover cosmetic issues such as dents,scratches,corrosion,surface rust,or the discoloration of surfa
heat,moisture,or exposure to sunlight.Regular maintenance of steel part is required to maintian appearance.Surface rust,corrosion,or
powder paint chipping on steel parts is not considered a manufacturing defect and is not covered under this warranty.
Figure 1
Figure 2
Figure 3 Figure 4
Figure 5
Figure 6
Fire bowl may be cleaned with water and mild detergent
Do not use abrasive detergents or pads to clean surround or fire bowl.
As with any outdoor grill, periodic maintenance is required toreturn painted
steel surfaces to original appearance. Remove anyrust with sandpaper or
steel brush and repaint with grill paint suitablefor high-temperature surfaces.
Follow manufacturer's instructions.
The fire pit and mesh spark screen are painted with a durablehigh-temperature
finish, but rusting will occur over time due to heatand moisture exposure.
Rusting may occur more quickly in areas witha higher humidity. Regular
maintenance is required to reduce theappearance of rust.