Datasheet

- 10 -
Installation
Single Stage
Refer to the installation diagram on the next page (the numbers
in the diagram correspond to the numbers of the steps) and do
the following:
1. Use a male-to-male DVI cable to connect your source
device’s DVI port to the VS162 / VS164’s Video In port.
2. Use a male-to-male audio cable to connect your source
device’s speaker port to the VS162 / VS164’s Audio In port.
3. Plug your DVI monitors and speakers into the A/V Out ports.
4. Plug the power adapter that came with your switch into an AC
power source, then plug the power adapter cable into the
switch’s Power Jack.
1. Make sure that the power to any device that you
connect to the installation has been turned off. You
must unplug the power cords of any computers that
have the Keyboard Power On function.
2. Make sure that all devices you will be installing are
properly grounded.