User manual

KVM Over the NET™ User Manual
52
The Java Client AP Connection Screen
A description of the Connection Screen is given in the following table:
Item Description
Server List Each time the JavaClient.jar file is run, it searches the User's
local LAN segment for KVM Over the NET™ switches, and
lists whichever ones it finds in this box. If you want to connect
to one of these units, double-click it. (See Connecting –
Windows Client AP, page 49 for details.)
Note: 1. The switch will not appear in the list unless its
Enable Device List configuration parameter has
been enabled. See Operating Mode, page 157 for
details.
2. Only units whose Access Port settings for Program
(see Service Ports, page 160) match the number
specified for Port in the Server area of this dialog
box appear in the Server List window.
Server
This area is used when you want to connect to a KVM Over
the NET™ switch at a remote location. You can drop down
the IP list box and select an address from the list. If the
address you want isn't listed, you can key in the target IP
address in the IP field, and its port number in the Port field. (If
you don't know the port number, contact your Administrator.)
 When the IP address and Port number have been
specified, click Connect. (See Connecting – Windows
Client AP, page 49 for details.)
 When you have finished with your session and come back
to this dialog box, click Disconnect to end the connection.
Message Panel Located just to the right of the Server panel, the Message
panel lists status messages regarding the connection to the
KVM Over the NET™ switch.
Switch to Remote View Once you have been authenticated (see Connecting –
Windows Client AP, page 49 for details), this button becomes
active. Click it to switch to the GUI Main Page. The GUI Main
Page is described on page 58.