User manual

- 13 -
Port Switching
There are two convenient methods to switch the KVM and Audio
focus between the computers: Manual – which involves pressing
the port selection pushbuttons located on the unit’s front panel;
and Hotkey – which involves entering combinations from the
keyboard.
Manual:
Press the Port Selection Pushbuttons as follows:
 Press a pushbutton for longer than two seconds to bring the
KVM and audio focus to the computer attached to its
corresponding port.
 Press a pushbutton for less than two seconds to bring only
the KVM focus to the computer attached to its corresponding
port.
 Press pushbuttons 1 and 2 simultaneously for 3 seconds to
start Auto Scan Mode. See p. 14 for details.
Hotkeys:
Key in the hotkey combinations according to the information in
the following table:
Hotkey Action
[Scroll Lock] [Scroll Lock]
[Enter]
Switches the KVM and audio focus from the
port that currently has the KVM focus to the
other port(1 to 2; 2 to 1).
Note: The KVM and audio focus both go to
this port even if they were on different ports
to begin with.
[Scroll Lock] [Scroll Lock]
[K] [Enter]
Brings only the KVM focus from the port
that currently has it to the other port. The
audio focus remains where it is.
[Scroll Lock] [Scroll Lock]
[S] [Enter]
Brings only the audio focus from the port
that currently has it to the other port. The
KVM focus remains where it is.
cs-1262_2007-08-27.fm Page 13 Wednesday, September 19, 2007 2:33 PM