User manual

- 12 -
Operation
Hot-Plugging
The CS-1262 supports hot-plugging – components can be
removed and added back into the installation by unplugging and
replugging their cables without the need to shut the unit down.
Powering Off and Restarting
If it becomes necessary to Power Off the Master View unit, before
starting it back up you must do the following:
1. Shut down all the computers that are attached to the switch.
2. Unplug the switch’s power adapter cable.
3. Wait 10 seconds, then plug the switch’s power adapter cable
back in.
4. After the switch is up, Power On the computers.
The Beeper
The CS-1262 beeps to provide information about its operations
as follows:
The Beeper can be toggled off and on with the following hotkey
combination:
[Scroll Lock] [Scroll Lock] [B] [Enter]
Beeps Meaning
1 Manual port changes
Start of Auto Scan Mode
Beeper disabled
2 Power On
End of Auto Scan Mode
Hotkey port changes
Beeper enabled
cs-1262_2007-08-27.fm Page 12 Wednesday, September 19, 2007 2:33 PM