User manual

- 10 -
Installation
Cable Connection
To set up your installation, refer to the installation diagram on the
following page (the numbers in the diagrams correspond to the
steps, below), and do the following:
1. Plug your keyboard, DVI monitor, mouse, microphone, and
speakers into the Console Ports located on the unit’s rear
panel.
2. Using a KVM cable set (provided with this package), plug the
DVI connector into any available DVI socket in the KVM Port
section of the switch, and plug the accompanying keyboard,
mouse, microphone and speaker connectors into their
corresponding sockets.
Note: 1. Use the end of the cable that has the shorter connector
leads – the end with the longer leads is for plugging into
the computer.
2. Be sure that all the plugs are in the same KVM Port
sockets (all in Port 1, all in Port 2, etc.).
3. The KVM Port sockets and cable plugs are color coded
and marked with an appropriate icon for easy
installation.
3. At the other end of the cable, plug the keyboard, DVI monitor,
mouse, microphone, and speaker connectors into their
respective ports on the computer.
1. Make sure that the power to all the devices you will
be installing has been turned off. You must unplug
the power cords of any computers that have the
Keyboard Power On function.
2. Make sure that all devices you will be installing are
properly grounded.
cs-1262_2007-08-27.fm Page 10 Wednesday, September 19, 2007 2:33 PM