User manual

1. 2. 3.
Installation
Before you begin, make sure that power to all the devices (Master View CS-114 and
PCs) you will be connecting up have been turned off.
Single Station Installation
1.Set the Master View CS-114's DIP Switch 4 to the ON (Cascade Disabled) position.
2.Plug the monitor, keyboard, and mouse into the Console port connectors (located to
 the left of the CPU ports) of the Master View CS-114 unit. Each port is labeled with 
 an appropriate icon to indicate itself.
3.Use either AT or PS/2 style extender cables to connect the keyboard and mouse 
 ports from any available CPU Port (CPU1 - CPU4), to the keyboard and mouse ports 
 of the PC, as shown in the diagram below.
4.Use a VGA extender cable to connect the CPU Port monitor port to the monitor port 
 of the PC, as shown in the diagram below.
5.Plug the DC power adapter into the Master View CS-114's Power Jack.
6.Turn on the power to the Master View CS-114.
7.Turn on the power to the connected PCs.
Note:You must turn on the power to the Master View CS-114 before turning on the
 power to the PCs.
AT KEYBOARD
PORT
VGA MONITOR PORT
PS/2 MOUSE
PORT
PS/2 KEYBOARD
PORT
VGA MONITOR
PORT
Rear View:
1. Console Port Section
Your monitor, keyboard, mouse, and DC 9V power adapter plug in here.
2. DIP Switch
A four segment DIP Switch. Switches 1 and 2 select the Scan Time; Switch 3 has no
assignment at this time; Switch 4 selects the Cascade Mode. See the table in the
Appendix for details.
3. CPU Port Section
The extender cables that connect the unit's monitor, keyboard and mouse ports to
the PC's monitor, keyboard and mouse ports plug in here.
VGA
MONITOR
PS/2 KEYBOARD
PS/2 MOUSE