User manual

- 12 -
Auto Scan Mode
The Auto Scan feature automatically switches between the two
computers at regular 5 seconds intervals, so that you can monitor
their activity without having to take the trouble of switching
yourself.
To invoke Auto Scan Mode, simply hold down the Port Selection
push button switch for two seconds. The Port LEDs flash when
their corresponding ports are accessed under Auto Scan Mode.
To turn Auto Scan Mode Off, simply press and release the Port
Selection switch. The LEDs stop flashing when Auto Scan Mode
is no longer in effect.
Note: 1. While Auto Scan Mode is in effect, ordinary keyboard
and mouse functions are suspended. You must exit
Auto Scan Mode in order to regain normal use of the
console.
2. The drivers for most USB devices (CCD Cameras,
Scanners, Printers, e.g.), are required to be shut down
before you disconnect the device, or else the system
may crash. When the computers switch under Auto
Scan Mode, it is the equivalent of disconnecting the
device. Therefore, if you have peripheral devices (other
than a second keyboard and mouse) connected to the
CS-102U's USB peripheral ports, you must be sure that
the USB drivers for them are shut down on both
comuters before invoking Auto Scan Mode.
cs102u.fm Page 12 Friday, June 6, 2008 3:42 PM