User manual

- 10 -
Note: 1. For PC users (Mac users do not need to do this step),
at bootup, enter the PC's CMOS Setup program (see
the on screen instructions at bootup for how to enter
the CMOS Setup program), and make the following
changes:
 In STANDARD CMOS, set HALT ON ERROR to:
ALL BUT KEYBOARD
 In PNP AND PCI SETUP, set PNP OS
INSTALLED to: YES; set USB IRQ to: ENABLED.
2. The CS-102U's Power On default is to link to Port 1.
If the computer attached to Port 1 is inactive, the
monitor will be blank so it may appear as if the unit is
not functioning. This is not the case. Simply press the
Port Selection Switch (located on the unit's top
panel), to switch to the active computer port.
3. When you start Computer 2 and the KVM focus is on
CPU 1, Computer 2's bootup routine will not
autodetect the monitor's capability. Under such
circumstances, the PC reverts to VGA mode. If this
occurs, switch to CPU2, then use Control Panel to
reset the resolution.
4. The Mac's keyboard Power On function is not
supported. You must start the Mac with its Power On
switch.
cs102u.fm Page 10 Friday, June 6, 2008 3:42 PM