User manual

4. Administration
25
(Continued from previous page.)
IP Installer Settings
An IP Installer utility (IPInstaller.exe) is provided on the software CD that
came with this package. It offers a simple method to ascertain and configure IP
related settings for the CN8000. When the IP Installer is invoked, it scans the
network for CN8000 devices and displays the ones it finds.
 Selecting Enabled, allows you to see the IP settings of the devices that
were found, and to use the utility to set new IP addresses.
 Selecting View Only, allows you to see the IP settings of the devices that
were found, but you cannot make any changes to the settings.
 Selecting Disabled, means that the CN8000 will not show up in the IP
Installer’s list of found devices.
See IP Installer, page 111, for operation details.
Finishing Up
After making any network changes, be sure Reset on exit on the Customization
page (see Customization, page 35) has been enabled (there is a check in the
checkbox), before logging out. This allows network changes to take effect
without having to power the CN8000 off and on.
cn8000.book Page 25 Tuesday, July 1, 2008 4:18 PM