User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
CN6000 User Manual
64
When you click Add or Edit, a dialog box with fields to configure the user
profile appears:
An explanation of the profile items is given in the table below:
Username A minimum of 6 and a maximum of 15 characters is allowed.
Password A minimum of 8 and a maximum of 15 characters is allowed.
Confirm
Password
To be sure there is no mistake in the password you are asked to
enter it again. The two entries must match.
Description Additional information about the user that you may wish to include.
Permissions Click to place/remove a check mark next to an item in order to
grant/deny access to an aspect of the CN6000’s operation as
follows:
Configure: Checking Configuregives a User Administrator
privileges, and allows the user to set up and modify the CN6000’s
operating environment.
Windows Client Checking Windows client allows a User to access
the CN6000 via the Windows Client software.
Java Client:Checking Java client allows a User to access the
CN6000 via the Java Client software.
Power Management:Checking Power Management allows a User
to access and operate an attached Power over the Net™ module.
Log:Checking Logallows a User to view the contents of the log file.
View Only:Checking View Only allows the User to view the video
display of the computers attached to the ports of the KVM switch
connected to the CN6000, but they are not allowed to perform any
operations on the computers.
cn6k_2007-02.book Page 64 Wednesday, February 28, 2007 9:26 AM