User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
CN6000 User Manual
56
Uploading Changes
When the Settings have been configured to your satisfaction and you are ready
to upload the changes to the CN6000:
1. If you made changes on the Network page, or if you upgraded the firmware
on the Customization page, you must enable Reset on Exit (see
Customization, page 65) before going to step 2.
2. Click OK (at the bottom of the Settings notebook), to start the updating
procedure.When updating has finished, the following message displays:
3. Click OK and you return to the Administration Utility device selection
screen (see page 52).
Note: To abandon the changes you made and return the settings to the
values they had before you ran the Utility, Click Cancel.(at the
bottom of the Settings notebook) instead of OK in step 1.
cn6k_2007-02.book Page 56 Wednesday, February 28, 2007 9:26 AM