User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
8. AP Operation
53
Note: 1. 1.The Port number that corresponds to a unit's IP address is set by the
Administrator on the Network configuration page (see page 58 for
details).
2. Clicking the Refresh button causes the utility to rescan the local LAN
segment for CN6000 devices.
3. If the utility fails to connect to a unit that you specified, it assigns
another free IP address (if one exists), to that device and attempts to
connect again.
4. When the Administrator Utility searches for CN6000 devices, if it
finds a unit that was originally on a different network segment that
still has a fixed IP address from its previous location, it will list the
unit (showing the IP address), but you cannot connect to it. You
should change the unit's IP address to match its current network
segment (see IP Address Determination, page 90, for details).
Logging In
Once the Administrator Utility connects to the unit you specified, a login
window appears:
Only those who have Configuration privileges (see User Management,
page 63) are allowed to log in.
Provide a valid Username and Password, then Click Login to continue.
Note: The default Username is administrator; the default Password is
password. You can change these to whatever you prefer (see User
Management, page 63) after you have logged in.
cn6k_2007-02.book Page 53 Wednesday, February 28, 2007 9:26 AM