User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
29
Chapter 5
The Windows Client
Starting Up
To access the CN6000 with the Windows Client software:
1. After you log in, Click the Windows Client icon at the left of the web page
(see page 12).
Note: You must have DirectX 7.0 or higher installed on your computer. If
not, the Client program will not load.
2. In the dialog box that comes up, click Open to run the program.
Note:.1. If the browser cannot run the program, save it to disk, instead.
Then, with your browser still open to the CN6000 web page, run
the file from your disk.
2. If you use the save to disk method, for security purposes, you
cannot simply run a previously downloaded version of the
program. Each time you want to access the CN6000, you must log
in to the web page with a valid username and password to
download a fresh copy of the program.
3. When a connection to the CN6000 has been established, a screen similar to
the one below appears:
cn6k_2007-02.book Page 29 Wednesday, February 28, 2007 9:26 AM