User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
CN6000 User Manual
20
Filtering
There are a maximum of 100 filters allowed for each category: User IPs; User
MACs; and Administrator MACs. User Station filtered items (IPs and MACs)
can be specified as included or excluded by highlighting the item and clicking
the include or exclude radio button.
If the include button is checked, all the addresses within the filter range are
allowed access to the CN6000; all other addresses are denied access.
If the exclude button is checked, all the addresses within the filter range
are denied access to the CN6000; all other addresses are allowed access.
User Station Filtering - IPs:
To enable IP filtering for User Stations, Click to put a check mark in the IP
Filter enable checkbox.
To add a filter:
1. Select whether to include or exclude the filter.
2. Click Add. A dialog box similar to the one below appears:
3. Specify the filter address in the dialog box, then Click OK.
Each IP filter can consist of a single address, or a range of addresses.
Therefore, a second dialog box similar to the one below appears:
cn6k_2007-02.book Page 20 Wednesday, February 28, 2007 9:26 AM