User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
2. Hardware Setup
9
Installation
To install the CN6000, refer to the diagram below (the diagram numbers
correspond to the numbered steps), and do the following:
1. Plug the local administrator's keyboard, mouse, and monitor into the unit's
Console Ports.
2. Use the KVM cable provided with this package to connect the CN6000’s
KVM Port, to the Keyboard, Video and Mouse ports of the server or KVM
switch that you are installing.
3. Plug the LAN or WAN cable into the CN6000's RJ-45 socket.
4. Plug the power adapter cable into the CN6000's power jack, then plug the
power adapter into an AC power source.
5. Power up your server or KVM installation.
1
4
3
KVM Switch
2
5
cn6k_2007-02.book Page 9 Wednesday, February 28, 2007 9:26 AM