User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
7
Chapter 2
Hardware Setup
Rack Mounting
For convenience and flexibility, the CN6000 can be mounted on a system rack.
To rack mount the unit do the following:
1. Using the screws provided with this package, screw the mounting bracket
into the top or bottom of the unit as shown in the diagram below.
1. Important safety information regarding the placement of this
device is provided on page iv. Please review it before
proceeding.
2. Make sure that power to all the devices you will be connecting
up have been turned off. You must unplug the power cords of
any computers that have the Keyboard Power On function.
Phillips hex head
M3 x 8
cn6k_2007-02.book Page 7 Wednesday, February 28, 2007 9:26 AM