User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
CN6000 User Manual
92
Method 3: (For a DHCP address)
For computers running Windows, the CN6000's DHCP generated IP address
can be determined with the AdminTool utility (found on the distribution CD):
1. Double click the AdminTool utility icon on the CD to install the utility on
your computer. When the installation completes, there is a CN6000
AdminTool icon on your desktop.
2. Double click the CN6000 AdminTool icon.
The utility searches the network segment for CN6000 devices, and
displays what it finds in a dialog box similar to the one below:
The DHCP assigned IP address appears in the right hand column of the
CN6000 Devices panel:
Note: 1. .If there is more than one device in the list, use the MAC address
to pick the one you want. The CN6000's MAC address is located
on its bottom panel.
2. If the list is empty, or your device doesn't appear, click Refresh
to refresh the Device List.
3. Click Exit to close the utility.
cn6k_2007-02.book Page 92 Wednesday, February 28, 2007 9:26 AM