User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
Appendix
91
Method 2: (For a fixed IP address)
A fixed IP address can also be assigned with the ARP command as follows:
1. If the CN6000 is powered on, Power it off by unplugging its power adapter
cable.
2. Run the ARP command with the following arguments:
arp -s <desired ip address> <CN6000's MAC address>
Where the IP address that you assign is one suitable for the network
segment that the CN6000 resides on.
Note: The CN6000's MAC address can be found on its bottom panel.
3. Power on the CN6000
4. From your browser, log into the CN6000 using the IP address you just
assigned.
Note: You must do this within 30 seconds of powering the CN6000 on.
cn6k_2007-02.book Page 91 Wednesday, February 28, 2007 9:26 AM