User manual
Table Of Contents
- CN6000
- FCC Information
- User Notice
- Safety Instructions
- Package Contents
- About this Manual
- Conventions
- ATEN Information
- Introduction
- Hardware Setup
- Getting Started
- Administration
- The Windows Client
- The Java Client
- The Log File
- AP Operation
- Appendix
- Index
CN6000 User Manual
90
IP Address Determination
If you are an administrator logging in for the first time, you need to access the
CN6000 in order to give it an IP address that users can connect to. There are
three methods to choose from. In each case, your computer must be on the same
network segment as the CN6000. If the CN6000's address was set by DHCP,
Method 3 will show you what the DHCP assigned address is.
After you have connected and logged in you can give the CN6000 its fixed
network address in the Network Settings dialog box (see page 17). If you want
to have the CN6000's address set by DHCP and the address changes, use
Method 3 to determine the new address.
Method 1: (For a fixed IP address)
When the CN6000 starts, if it doesn't find a DHCP environment after 30
seconds, it automatically sets its IP address to 192.168.0.60.
1. Set your computer's IP address to 192.168.0.XXX
Where XXX represents any number or numbers except 60.
2. Specify the switch's default IP address (192.168.0.60) in the URL entry
box of your browser.
3. After you connect and log in, assign a fixed IP address for the CN6000
that is suitable for the network segment that it resides on.
4. After you log out, be sure to reset your computer's IP address to its original
value.
cn6k_2007-02.book Page 90 Wednesday, February 28, 2007 9:26 AM