User Manual

- 12 -
3. For increased grounding protection, use STP (shielded
twisted pair) cable to connect the Local and Remote Units.
There are two methods that can be used:
a) In addition to the eight paired wires, STP cable also
contains a grounding wire. Solder this wire to the RJ-45
connector as shown in the diagram below:
b) The second method is to use the STP cable shielding for
grounding. In this case, make sure that the shielding
makes tight contact with the top inside of the RJ-45
connector as shown in the diagram below:
In either case, make sure that the sides of the RJ-45
connector make tight contact with the grounding contacts on
the sides of the RJ-45 socket as shown in the diagram below:
Setting up the USB KVM Extender system is simply a matter of
plugging in the cables. Refer to the installation diagram on the
following page and do the following: