User manual

- 9 -
Hardware Installation
Before you Begin
Setting up the CE-252 is simply a matter of plugging in the
cables. Refer to the installation diagram on the following page
(the numbers in the diagram correspond to the numbered steps)
and do the following:
1. Connect the local console devices (mouse, keyboard and
monitor) to the ports on the rear of the Local Unit (CE-252L).
2. Plug the provided KVM cable into the appropriate connector
on the front of the CE-252L, then plug the connectors on the
other end of the KVM cable into the appropriate ports on the
computer system (or Console section of the KVM switch - if
you are using one).
Each connector is marked with an identifying icon.
3. Connect one end of a Category 5 twisted pair cable to the
Remote I/O port on the CE-252L, then plug the other end of
the Category 5 twisted pair cable into the Remote I/O port on
the CE-252R.
4. Connect one of the provided power adapters into an AC
source, then connect the adapter's power cable to the Power
Jack on the rear of the CE-252L.
1. Ensure that all equipment to be connected is pow-
ered off.
2. Make sure that all devices you will be connecting up
are properly grounded.
3. Unplug the power cords of any computers that have
the Keyboard Power On function.
CE252.fm Page 9 Friday, September 15, 2006 12:08 PM