User Guide

ManualsBrandsATEL ManualsOtherATEL V810T 4G LTE Phone Hub

Meet Your Device

ATEL

4G LTE Cat-4 Home Phone Connect

Voice-Only POTS Replacement

1. LCD Display

Displays Home and Device

Information display screen

5. SIM Card Slot

As needed, insert your 4FF

Nano SIM card into this spring-

loaded SIM slot. To remove,

press the SIM inward.

2. Power Button

Power the V810 On/Off by

pressing and holding this

button for up to 10 seconds.

Short press to wake up the

screen.

6. Type C Port

Use this port to connect the

USB-C cable to a wall adapter

for external power.

3. Battery Port

Battery port connect to the AA

battery (AA batteries Included)

holder or a Ni-MH

rechargeable battery pack

(sold separately).

7. Phone Port (RJ11)

Use a telephone cord to

connect your telephone base

to this port.

4. Reset Button

Use a pin to push and hold this

button for 3 seconds for a

factory reset.

8. Antenna Connector

Install an optional antenna

(sold separately) to increase

signal strength. You may have

to pull off the back rubber

cover prior to installing.

A quick look at your device:

Models Covered:

Version 2.3

Model

LTE

Bands

810T

2/4/5/12/66/71

810V

2/4/5/12/13/66/71

Summary of content (4 pages)

PAGE 1
A quick look at your device: Meet Your Device ATEL 1. 4G LTE Cat-4 Home Phone Connect Voice-Only POTS Replacement Models Covered: Model V810T V810V LTE Bands B2/4/5/12/66/71 B2/4/5/12/13/66/71 Version 2.3 LCD Display Displays Home and Device Information display screen 2. Power Button Power the V810 On/Off by pressing and holding this button for up to 10 seconds. Short press to wake up the screen. 3.
PAGE 2
Setting up your device: Step 1: Insert a SIM (if applicable) a) b) c) d) Remove the back cover. Carefully lift the battery holder from the side. Check for a pre-installed SIM card or install a SIM card provided by your wireless carrier. To install, insert the 4FF SIM card into the springloaded SIM slot as the image shows. To remove a SIM, press the edge of the SIM inward and the SIM will pop outward from the slot.
PAGE 3
Step 4: Connecting a Telephone to your V810 Step 5: Initial Activation a) b) Once the above 4 steps are completed, with a service plan subscription, your V810 with automatically detect the wireless network and activate the SIM card services. The wireless network and signal strength indicator will appear on the status bar of your Welcome Home screen. It might take a few minutes for the initial activation. Complete Steps 1, 2 and 3 above.
PAGE 4
For more information Please refer to your V810 User Manual for additional information or visit the ATEL USA website Device and Support pages at www.ATEL-USA.com.