User Guide

1. Remove the V810A back
cover.
2. Install the 4FF Nano SIM card
into the spring-loaded SIM slot
as the image shows. To
remove a SIM, press the edge
of the SIM inward and the SIM
will pop outward from the SIM
slot.
Installing a NiMH Battery
1. Remove battery cover.
2. Properly align and install the NiMH battery (with three pin
sockets). Make sure to align the pin sockets correctly.
3. Put the NiMH battery in place as shown below.
4. Replace the back cover of the V810A and make sure it’s
aligned with the bottom of the device.
Note: the NiMH Battery may be sold separately.
5.
SIM Card Slot
Insert your 4FF SIM card
into this spring-loaded
SIM slot. To remove a
SIM, press the edge of
the SIM inward and the
SIM would pop outward
from the SIM slot.
7.
Ethernet Port (RJ45)
Insert an ethernet cable to
this Port and plug the
other end into your
computer for internet
access.
6.
Type-C Port
Use this port to connect
the USB-C cable to a
wall adapter for external
power.
8.
Antenna Connector
Install an optional antenna
(may be sold separately)
to increase signal
strength.
Setting up your V810A
Install SIM Card