User Guide

Optional Add-On’s: Indoor WiFi AP
To bring LTE High Speed data connection to share with
multiple devices over LAN or WiFi, simply connect the J-
Series ODU with our indoor WiFi AP (built-in POE).
You can contact us to learn more about the ATEL Indoor WiFi
AP on our website,
https://www.atel-usa.com/.
If you are using other cables or devices that are compatible
with our AOL-J ODU, please refer to their user manual to
connect with our ODU for data services over the LTE
Network.
Factory Resetting of Your J-Series ODU
You can reset your ODU to factory default from the Online
Portal or the reset button.
Note: Resetting your ODU will erase all the changes you
have done and boot up with factory default settings.
A. To reset the device from the Online Portal, click
Settings > Basic > Management. Click on “Restore” to
factory default settings.
B. To reset the ODU from the reset button (refer figure 1),
make sure your ODU is powered on. Insert a pin into
the Reset pin hole, push down and hold for 3 seconds.
The device will restore the factory defaults and reboot.
The ODU must have an uninterrupted power supply during Reset.
Any power failure might result in a hardware failure.
Unable to Access Internet?
1. Check that all LEDs on ODU are lit up. If not, refer to
table 1 and check each LED for current status.
2. Make sure your SIM card is active and internet on the
4G-LTE network is accessible/active.
3. Try resetting your ODU.
4. If an issue still exists, kindly contact to your data service
provider.
J-Series ODU
LTE Cell Tower
PoE Injector