User Guide

To Mount on a Wall
Note: Wall Mount tools and installation
kit items are not included.
Fix Mounting Brackets to ODU
1. Use four screws to attach the
mounting bracket to the rear
panel of the ODU.
If required, use screws used to
stack two mounting brackets
together, allowing the ODU
CPE’s angle to be adjusted
horizontally or vertically.
Fix Mounting Bracket to the Wall
1. Place the U-shaped mounting
bracket against the wall in the
desired position and mark the
location for holes.
2. Use a 4mm drill bit to make
four holes approximately
30mm deep, then insert four
wall anchors into the holes.
3. Use four screws to attach the
ODU with mounting bracket to
the wall.
Affix/Align Mounting Brackets
1. Unscrew the screws used to stack two mounting brackets
together. This also helps the ODU CPE’s angle to be
adjusted horizontally or vertically depending upon wall
/pole side mounting bracket installation.
2. Place the mounting brackets over the U-shaped bracket.
Position the ODU CPE at the desired angle and attach it
with four screws.
Screws on
the Wall
Screws on Mounting
Bracket
#2 Phillips
Head
Screws