User`s manual

Operating and Safety Instructions
15
7. OPERATION
7.1. BEGINNING OF THE WORK
7.1.1. Ensure that the machine table and all kind of parts are clean and dry. Degrease
and dry the machine table. Especially ensure that the holding grips and handles are
clean and dry.
7.1.2. Clean all surfaces of the machine from chip and foreign particles. Use eye glasses
for protection.
7.1.3. Check with the appropriate keys that the router bit is tightened properly.
7.1.4. Check the router bit for wear, bending and breaking. Replace them if damaged.
7.1.5. The portable copy router machine LIBRA is used for opening of key lock shapes,
hinge slots, window fastening slots and holes, slot channels in different dimensions
independently from the copying onto non-ferrous aluminum materials and hard plastic
materials or wood.
7.1.6. Fix the aluminum or PVC profile, which you want to process, with the fixed clamps
on the machine table. Chose the shape on the copy template, which you want to
copy onto the profile.
7.1.7. Keep the switch button on the movable head pressed (Figure 5, No. 15) to rotate
the router bit.
7.1.8. Keep the switch button on the movable head pressed (Figure 5, No. 15) to rotate
the router bit. At the same time, move the arm inside the shape slot to copy the
selected shape onto the profile. Push the arm (Figure 5, No. 15) down as far as it is
necessary for the routing operation on the profile.
7.1.9. At the end of the copying operation, release the Start button. The router bit will
come to a full stop within approx. 10 sec. After releasing the button.
7.1.10. Open the clamps and take out the processed part.
7.1.11. The machine is equipped with horizontal clamps. These horizontal clamps can be
easily adjusted according to the profile.
7.1.12. Do not process the profile before clamping the work piece properly.
7.1.13. The router bit should be moved down only after the regular rotation has been
reached.
CAUTION !
CAUTION !