User's Manual

D I G I TAL OSD (On Screen Display) Display
Selection and Control
Front Monitor
It makes OSD menu picture appear or disappear.
It is also used when you enter into or get out of submenu.
❶ MENU Button
Use SELECT button if you wish to change OSD value.
SOURCE will change when you press SELECT button. (If you press once, the present
SOURCE will appear. Press once more, the SOURCE will convert.)
❷ SELECT Button
When you press this button, it is automatically adjusted to the most appropriate condition
to present mode. This does not function when DIGITAL VIDEO CARD (DVI Card) is
used. (It is adjusted automatically.)
❼ A U T O Button
Use these buttons when moving up and down in OSD (It is TV channel increase
(UP) and decrease (DOWN) function when this button is pressed without pressing
MENU button.)
❸ DOWN Button ❹ UP Button
It is used to increase and decrease the SELECTION ICON value in OSD display. (It
is the VOLUME increase and decrease function when this button is pressed without
pressing MENU button.)
❺ LEFT Button ❻ RIGHT Button
❶ ❷ ❸ ❹ ❺ ❻ ❼ ❽
Once pressed, it powers up the system. Once more, it shuts down the system.
- Green ON : system activated - Amber ON : 1. System Standby
2. Monitor Power Saving Mode
3. VGA signal cable Unhooked
❽ POWER Button
Lights up during the opera-
tion but goes out if you turn
the power off.
Power Pilot Lamp
The Name and Function of Each Individual Part in the Screen Adjusting Block