User's Manual

H ow do I c onnec t the c omput e r cabl e s ?
How do I connect with the IBM computer ?
◈ In case of the monitor aiding DIGITAL (DVI)
Ensure that the computer, monitor and peripheral equipment power is
turned off.
Connect Signal Cable.
① In case of using DIGITAL Cable.
- Connect one DVI Signal Cable each to the mainframe and monitor.
② In case of using ANALOG Cable (Refer to the left side illustration).
- Connect DVI to VGA adaptor positioned at the rear side of the monitor.
Then connect it to the mainframe.
Connect one DC power jack of DC power supply unit to the 12V
terminal, and the other to the power cord. Next connect the power
cord to the concent.
Turn the monitor power on after switching the computer power on.
If "NO INPUT SIGNAL" appears, check the DVI Cable (or VGA Signal
Cable connection).
Switch the monitor and computer power off at the end of use.
Audio Cable
▶ AUDIO Cable is connected
to LINE OUT
DVI Signal Cable
DC Power Supply Unit
Power Cord
In ca s e of u s ing ANALOG in
DVI m o d e l m on ito r, yo u
m u s t s e t u p th e a da pt o r a s
s h o wn on th e illu s t ra tion .
▶ R e f e r e n c e
1 .
2 .
3 .
4 .
5 .
6 .