User's Manual

H ow do I connect the computer ca bl e s ?
How do I connect with the IBM computer ?
◈ In case of the monitor aiding ANALOG (VGA)
Ensure that the computer, monitor and peripheral equipment power is
turned off.
Connect signal cable to D-Sub signal input connector, and VGA signal
cable to signal input connector of monitor.
Connect one DC power jack of DC power supply unit to the 12V
terminal, and the other to the power cord. Next connect the power
cord to the concent.
Turn the monitor power on after switching the computer power on.
If the message“ NO INPUT SIGNAL” shows up, check the connection
of VGA signal cable or connector.
Switch the monitor and computer power off at the end of use.
Audio Cable
▶ AUDIO Cable is connected
to LINE OUT
VGA Signal Cable
DC Power Supply Unit
Power Cord
1 .
2 .
3 .
4 .
5 .
6 .
▶ R e f e r e n c e
N o I n p u t s ig n a l m e s s a g e
It is a m e s sa g e a pp e a re d in
ca se s ign a l in pu t ca b le is
in e xa ct ly co n n e ct e d b e tw e e n
m on it o r a nd com p u t e r.
Ple a s e r e fe r t o t h e m e s s a ge
“ Ple a s e co n firm b e for e yo u
re po rt t h e t rou ble”for d e ta ils .
Co n n e c t w it h t h e
Ma c in to s h c o m p u t er
Us e th e a pp r op ria t e MAC to
VGA a da pt e r b lock a t y ou r
s y s t e m .