User's Manual

No signal message
If the signal input cable
between the monitor and
computer isn’t correctly
connected, this message will
be displayed on the screen.
For more information, please
refer to ‘T r o u b l e s h o o t i n g’.
Attention for the use of 110V
If a consumer, lives in a district
where the 220V power supply
is unavailable, a 110V adapter
can be used. Purchase a stan-
dard product rated above 15A
and 250V with the mark of
“K S ”or “C h u n ”(in Korean) in
a sales agency specializing in
electric parts. Using a non
-standard product may cause
an electric shock accident.
How do I connect with the IBM computer ?
How do I connect the computer cables?
Ensure that the computer, monitor and peripheral equipment
power is turned off.
Connect signal cables with the D-sub signal input connector and
the monitor signal input connector respectively.
Connect one DC power jack of DC power supply unit to the 12V
terminal, and the other to the power cord. Next connect the power
cord to the concent.
Turn the monitor power on after switching the computer power on..
If the message “No Signal”appears, check connections of the
signal input cable or connector.
Switch the monitor and computer power off at the end of use.
Power Cord
D-Sub Signal Cable
DC Power Supply Unit
1 .
2 .
3 .
4 .
5 .
6 .