Owner's Manual
Jack Stands are designed to support stated capacity. Stands should only be used to
support par
al loads that consist of one end of a vehicle. Always use as a matched pair
to support one end of a vehicle only.
Never use jack stands to support
both ends or one side of a vehicle.
Use only one (1) pair of stands per vehicle.
3
SETUP, OPERATION & PREVENTIVE MAINTENANCE
Prior to each use, visual inspec on (See Pg. 6) should be made to the device by checking
for abnormal condi
ons, such as cracked welds, leaks, and damaged, loose, or missing
parts.
Consult the vehicle owner’s manual to determine the loca on of li points.
Be sure to set the vehicle in park with the emergency brake on and wheels securely
chocked.
Be sure that the vehicle and the jack are on a hard, level surface.
Service Jack
Assemble the upper sec on of the two piece handle into the lower sec on, line up the
holes, insert and
ghten the screw.
Insert the bo om end of handle into handle fork and securely ghten the bolt and
washer. Ensure the handle can turn freely.
Turn the handle/release valve clockwise to the closed posi on. Do not over ghten.
Posi
on the jack under the speci ed li point.
Begin li
ing by pumping the handle up and down.
Immediately a er li ing, insert safety pins into the appropriately rated jack stands and
Turn the handle/release valve slowly counterclockwise to lower the vehicle onto jack
stands.
SETUP
ASSEMBLY
LIFTING
support the vehicle. NEVER support the vehicle with only the jack.
SAFETY & WARNING INFORMATIOE;ŽŶƟŶƵĞĚͿ
This jack is designed toƌĂŝƐĞƚŚĞǀĞŚŝĐůĞŶŽƚƚŽƐƵƉƉŽƌƚƚŚĞǁĞŝŐŚƚŽŶŝƚƐŽǁŶŽŶĐĞůŝŌĞĚ
Support the vehicle with jack stands as outlined below.