user manual

Separating Bearing Housings
• Select the proper size Bearing Separator Jaw (2.2"~3.0" #2 or 2" #14) for the bearing size being separated.
Refer to Picture 2 below.
• Loosen the Separator Jaw Nuts (3 or 15) sufficiently to allow the Jaws to catch between each bearing
housing.
• Using a wrench (not supplied) begin to tighten Nuts (3 or 15) until the Jaws are securely set between the
bearing housings.
• Screw in the selected Extension Screws as shown below. The Extension Screws allows the user to grip them
and add stability while tightening Nuts (3 or 15).
• Continue tightening Nuts (3 or 15) until the bearing housing are separated. When the bearing housings are
separated, remove the Bearing Separator Jaw (2.2"~3.0" #2 or 2" #14).
Caution: Over tightening Separator Jaw Nuts may damage bearings.
Maintenance
• Wipe off components of the Bearing Separator Set of all grease and dirt.
• Store all components in the Case, and place in a clean and dry location.