ATD-3056 5-TON BAR TYPE PULLER/BEARING SEPARATOR SET Made in China to ATD Inc.
WARNING: When using this tool, basic safety precautions should always be followed to reduce the risk of personal injury and damage to equipment. Read all instructions before operating. Safety Warning and Precautions • Keep work area clean. Cluttered areas invite injuries. • Observe work area conditions. Do not use machines or power tools in damp or wet locations. Don’t expose to rain. Keep work area well lighted. • Keep children away. Children must never be allowed in the work area.
Product Safety Precautions • Be certain that the separator jaws are evenly set between bearing halves before attempting to separate. • Lead Screw (5) should be centered on the shaft where the bearings are being pulled to avoid damaging shaft or bearing housing. • Avoid pinching or scraping the bearing shaft by securely (and squarely) placing the Jaws around the bearing housing. • Use care when removing the Lead Screw (5) from the case to avoid damaging the threads.
Separating Bearing Housings • Select the proper size Bearing Separator Jaw (2.2"~3.0" #2 or 2" #14) for the bearing size being separated. Refer to Picture 2 below. • Loosen the Separator Jaw Nuts (3 or 15) sufficiently to allow the Jaws to catch between each bearing housing. • Using a wrench (not supplied) begin to tighten Nuts (3 or 15) until the Jaws are securely set between the bearing housings. • Screw in the selected Extension Screws as shown below.
ITEM# ORDERING PART# 1 PRT3056-01 2 PRT3056-02 3 PRT3056-03 4 PRT3056-04 5 PRT3056-05 6 PRT3056-06 7 PRT3056-07 8 PRT3056-08 9 PRT3056-09 10 PRT3056-10 11 PRT3056-11 12 PRT3056-12 13 PRT3056-13 14 PRT3056-14 15 PRT3056-15 16 PRT3056-16 17 PRT3056-17 PART DESCRIPTION SCREW, M12×1.25 MALE THREADS BEARING SEPATATOR JAW, 2.2" ~ 3.0 " CAPACITY (2 HALVES) NUT, M12×1.
