user manual

LED board replacement instructions
• When repairing your ATD Saber Li-Ion Worklight, do not allow any metal to come in contact with the internal battery
pack or the PC board and its components.
• Turn the ATD Saber Li-Ion Worklight
off.
• Remove end cap (2) from end of tube (3) using care not to crack the tube (3).
• Pull the LED PC board (8) from top of the tube (3).
• Disconnect the wiring connector from the LED PC board, and reconnect it to a new PC board (8).
• Carefully slide the PC board assembly (8) back into clear tube (3) and replace the end cap (2).
The ATD Saber Li-Ion Worklight is NOT waterproof, and is NOT intended to be used in showers, saunas, or
any other potentially wet locations. Keep the ATD Saber Li-Ion Worklight
away from sinks, tubs, showers, etc. Retrieving
ANY
electrical appliance when they fall into the water can be fatal.
The ATD Saber Li-Ion Worklight is to be used for general indoor lighting. It is NOT intended to be used in potentially
hazardous locations such as near flammables or in explosive atmospheres.
Your ATD Saber Li-Ion Worklight has a built in automatic discharge shut off feature that prevents the battery from
becoming fully discharged, thus extending the battery life.
Your ATD Saber Li-Ion Worklight
can be used when plugged into the AC adapter for recharging. It will not recharge while
it is in use however.
The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and
situations that may occur. It must be understood by the operator that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
U.S. Patent Number D548,382