user manual

Operation
NOTICES: Read and understand all warning
and precaution statements listed in the safety
section of this operation manual prior to using
this meter. Set the function select switch to the
OFF position when the meter is not in use.
AC/DC Current Measurements
WARNING: Ensure that the test
leads are disconnected from the
meter before making current clamp
measurements.
1. Set the Function switch to the
80ADC, 4ADC, 80AAC or 4AAC
range. If the range of the measured
is not known, select the higher range
first then move to the lower range if necessary.
2. Press the trigger to open jaw. Fully enclose one
conductor wire to be measured.
3. If measuring DCA, press ZERO button to
enter the zero reading.
4. The clamp meter LCD will display the reading.