User's Manual

3
INSTALLATION
1. If this is a new installation, you must first remove the
air motor plug. When doing this, position the jack
to allow easiest access to the motor connection.
Remove threaded plug, save for future use.
Note. Hydraulic cartridge is found in the above cavity,
do not remove. Ensure that cartridge is positioned as
illustrated.
2. Ensure that the motor connection seal and washer is
in place on drive end housing of motor, then carefully
thread the air motor assy clockwise until handtight.
Use 27mm open end wrench, tighten to 105 ft-lbs.
If you are replac
ing an ATD Tools air motor, simply
remove the old unit and install in the same manner as
described above
MAINTENANCE
Periodically in-line lubrication using a good quality
air tool lubricant. When used daily, pour a teaspoon
of proper lubricant into the air inlet of the lift control
valve. Connect valve to air supply and squeeze valve
lever to operate. This will evenly distribute lubricant
and properly prepare the hydraulic power unit for use.
Periodically check for leaks at air connections. Use
thread compound to repair. Avoid the use of thread
tape when possible.
REPLACEMENT PARTS
(refer to page 4)
Not all components of the air motor are replacement
items, but are illustrated as a convenient reference of
parts location. When ordering parts, give model number
and parts description. Call or write for current pricing:
Atd Tools Inc. 160 Enterprise Drive, Wentzville, MO
63385. Tel:[phone] Fax:[phone]
ONE YEAR LIMITED WARRANTY
For a period of one (1) year from date of purchase, ATD Tools Inc. will repair or replace, at its option, without
charge, any of its products which fails due to a defect in material or workmanship under normal usage. This limited
warranty is a consumer's exclusive remedy.
Performance of any obligation under this warranty may be obtained by returning the warranted product,
freight prepaid, to ATD Tools Inc. Warranty Service Department,160 Enterprise Drive, Wentzville, MO 63385.
Except where such limitations and exclusions are specifically prohibited by applicable law, (1) THE
CONSUMER'S SOLE AND EXCLUSIVE REMEDY SHALL BE THE REPAIR OR REPLACEMENT OF DEFECTIVE
PRODUCTS AS DESCRIBED ABOVE. (2) ATD Tools Inc. SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL
OR INCIDENTAL DAMAGE OR LOSS WHATSOEVER. (3) ANY IMPLIED WARRANTIES, INCLUDING WITHOUT
LIMITATION THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE, SHALL BE LIMITED TO ONE YEAR, OTHERWISE THE REPAIR, REPLACEMENT OR REFUND AS
PROVIDED UNDER THIS EXPRESS LIMITED WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER,
AND IS PROVIDED IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR IMPLIED. (4) ANY MODIFICATION,
ALTERATION, ABUSE, UNAUTHORIZED SERVICE OR ORNAMENTAL DESIGN VOIDS THIS WARRANTY AND
IS NOT COVERED BY THIS WARRANTY.
Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not
apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the
above limitation or exclusion may not apply to you. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.