User's Manual

Installing the paper rolls:

1. Each spring bar assembly is designed to hold a full roll of paper. Select either spring bar

for installation of a new roll of paper.

2. Remove the wing nuts on both sides of the spring bar assembly, and place the

assembly on your workbench for installation of the paper.

3. Loosen the screws in one or both of the retainer sets, and slide them off the spring bar.

4. Slide a paper roll onto the spring bar, abutting the remaining retainer set. The paper roll

should be positioned so that when the spring bar assembly is re-installed onto the

masking station the paper will pull off the top of the roll toward the cutting blades.

5. Slide the retainers back onto the spring bar assembly, and replace the assembly back

onto the masking station.

6. Retighten the screws in the retainers to hold the paper roll firmly in position.

7. If desired, you may align the paper with the edges of the tape rolls. To do so, loosen the

screws in both sets of retainers, and slide them with the paper roll along the spring bar

until the edges of the paper roll is aligned with the center of the tape rolls. Tighten the

screws in the paper retainers to secure this position on the spring bar.