User's Manual

ManualsBrandsATD Tools Manualschassis componentsATD-8525

ATD-8525

20 GALLON PARTS WASHER INSTRUCTION

MANUAL

IMPORTANT SAFETY INSTRUCTIONS

1. Read all instructions before using this unit.

2. Care must be taken as burns can occur from touching hot parts.

3. Do not operate the equipment with a damaged cord or if the equipment

has been dropped or damaged. Return the equipment to our service

center for examination or mechanical adjustments or repair.

4. Do not let cord hang over edge of table, bench or counter or come in

contact with hot manifolds or moving fan blades.

5. If an extension cord is necessary, a cord with a current rating equal to or

more than that of the equipment should be used. Cords rated for less

current than the equipment may overheat. Care should be taken to

arrange the cord so that it will not be tripped over or pulled.

6. Always unplug equipment from electrical outlet when not in use. Never use

the cord to pull the plug from the outlet. Grasp plug and pull to disconnect.

7. Let equipment cool completely before putting away. Loop cord loosely

around equipment when storing.

Summary of content (5 pages)

PAGE 1
ATD-8525 20 GALLON PARTS WASHER INSTRUCTION MANUAL IMPORTANT SAFETY INSTRUCTIONS 1. Read all instructions before using this unit. 2. Care must be taken as burns can occur from touching hot parts. 3. Do not operate the equipment with a damaged cord or if the equipment has been dropped or damaged. Return the equipment to our service center for examination or mechanical adjustments or repair. 4.
PAGE 2
8. To reduce the risk of fire, do not operate equipment in the vicinity of open containers of flammable liquids (gasoline). 9. Adequate ventilation should be provided when working on operating internal combustion engines. 10. Keep hair, loose clothing, fingers and all parts of body away from working parts. 11. To reduce the risk of electric shock, do not use on wet surfaces or expose to rain. 12. Use the equipment only as described in this manual. Use only manufacturer’s recommended attachments. 13.
PAGE 3
ASSEMBLY INSTRUCTIONS: 1. Remove machine from carton and inspect for any visual damage. 2. Remove parts from inside the machine 3. Lay cardboard on the floor and lay machine on its lid (Make sure to hold the cover closed when laying machine on its lid.) 4. Mount four legs on brackets with M6x12 screws, Lock washers and M6 nut. NOTE: DO NOT TIGHTEN YET. 5. Place lower shelf between legs with flat surface up and attach to legs with M6X12 screws, Lock washers and M6 nuts. 6.
PAGE 4
TECHNICAL SPECIFICATIONS: Model ATD-8525 Overall Dimensions 30-3/4"X21-3/4"X35-3/4" Tank Dimensions 29-7/8"X20-3/4"X10-8/10" Max Solvent Capacity 20 Gallons Max Pump Output 5.
PAGE 5