Instruction manual

UNPACKING AND CONTENTS
IMPORTANT: Due to modern mass production techniques, it is unlikely the tool is faulty or that a part is missing. If
you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified.
Failure to do so could result in serious personal injury.
Package Contents
Item Description .......................................................... Qty
- Bench grinder ..................................................... 1
D Tool rest locking knobs ....................................... 2
F Left tool rest ........................................................ 1
L Left spark guard .................................................. 1
M Eye shields ......................................................... 2
N Eye shield locking knobs .................................... 2
P Eye shield brackets ............................................. 2
Q Spark guard / eye shield bracket locking knobs .. 2
R Right spark guard ............................................... 1
S Right tool rest ..................................................... 1
i Small flat washers............................................... 4
ii Large flat washers .............................................. 2
iii Small lock washers .............................................. 2
iv Large lock washers .............................................. 2
v Star lock washers ................................................. 2
vi Tool rest bolts ...................................................... 2
vii Operator’s manual (not shown) 1
WARNING! If any parts are missing or damaged, do not attempt to assemble the tool, plug in power cord or turn the
switch on until the missing or damaged parts are replaced.
ASSEMBLY AND ADJUSTMENTS
WARNING! Always be sure that the tool is switched off and unplugged from the power source before any
adjustment, attachment of accessories, or maintenance check on the tool.
ATTACH AND ADJUST SPARK GUARDS AND EYE SHIELDS
NOTE: Always ensure the eye shields are well attached and the spark guards are properly adjusted before each
time the grinder is used. Eye shields and spark guards must be attached and correctly positioned over both grinding
wheels.
1. You’ll find a left (L) and a right (R) spark guard. Check the picture for the mounting position of each of them.
Follow steps 2 to 8 below to attach the spark guard and eye shield on the left side of the grinder.
2. Insert spark guard / eye shield bracket locking knob (Q) through a large lock washer (iv), a large flat washer (ii),
the eye shield bracket (ii) and the left spark guard (L)
3. Screw the knob into the hole in the left wheel guard. Tighten it sufficiently so it holds the spark guard and the
eye shield bracket in place.