Instruction manual

• Always work using the face of the grinding wheel with the wheel’s surface moving downward into your work
piece.
• Do not use the side of the wheel to perform grinding operations.
• Note the original bevel angle on the item sharpened and try to maintain this shape.
MAINTENANCE
CLEANING
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use a clean cloth to remove dirt, dust, oil, grease, etc.
WARNING! Never allow brake fluids, gasoline, petroleum- based products, penetrating oils, etc., to come into
contact with plastic parts. Chemicals can damage, weaken, or destroy plastic which may result in serious personal
injury.
Any electric tools used on fiberglass, wallboard, spackling compounds, or plaster can suffer from accelerated wear
and possible premature failure because the chips, grindings, and debris produced are very abrasive, especially to
components such as bearings, brushes, and commutators. We do not recommend using this machine to work on
these types of materials for any length of time. If you do work with any of these materials, try to mitigate the damage
and clean the tool frequently using compressed air.
LUBRICATION
This tool is permanently lubricated at the factory and requires no additional lubrication.