User`s guide

Operation
90
Figure 16 Dimensions of the Automated Thermal Desorber
(example shown here is the TurboMatrix Series 300 TD)
To begin operation of the ATD or TD:
1. Connect the electrical and gas supply lines, set the
required flow rates and check all gas connections. Refer
to Chapter 2 for details.
2. For the Manual Pneumatics Models 100 nd 150, setup
the gas flow rates as outlined in Setting the Carrier Gas
Flows on page 77.
CAUTION
Do not power up the GC until you have connected a supply of
carrier gas and very dry air.
48 cm
(19”)
56 cm (22”)
43 cm (17”)
Tube Loading
Area
Carousel
Touch Screen
Display
Transfer Line
Receptacle
Pneumatic
Adjustments