User`s guide

Contents
iii
Temperature Tab ....................................................97
Timing Tab.............................................................99
The Options Tab...................................................103
Operating Modes..................................................107
Pneumatics Tab ....................................................109
The Log Tab.........................................................110
Tools ...........................................................................112
Method Editor ......................................................112
Save As.................................................................114
Preferences ...........................................................115
Calculator .............................................................115
Reset.....................................................................115
Log Out ................................................................115
Maintenance Tab..................................................116
Preferences Tab...........................................................117
Run Tab.......................................................................117
Config Tab ..................................................................119
Setup Tab ....................................................................120
Connect Tab .........................................................124
Loading Tubes......................................................125
Loading the ATD Carousel........................ 125
Loading a Single Tube into the TD......................126
Single Method Operation on the TD....................128
Single Method Operation on the ATD.................129
Multiple Method (Sequence) Operation...............130
Shutdown..............................................................131
Programmable Pneumatics Control (PPC)
TurboMatrix Series 300 TD, 350ATD and 650 ATD 132
System Setup........................................................132
The Run Tab.........................................................133
Single Method Operation........................... 133
Creating a Sequence .................................. 134
Editing a Sequence .................................... 136
Temperature Tab ..................................................136
Timing Tab...........................................................139
The Options Tab...................................................144
Operating Modes..................................................148
Pneumatics Tab ....................................................151
The Log Tab.........................................................154
Tools.....................................................................156
Maintenance Tab..................................................160
Preferences Tab....................................................162