User`s guide

Installation and Setup
37
Space Requirements for the Instrument
The space requirements for the instrument are shown in Table 6. You
should leave sufficient room around the instruments to access all of
the connections at the rear, and reach the electrical supply points.
The TurboMatrix Series TD models are the 100 and 300. The
TurboMatrix Series ATD models are the 150, 350 and 650.
Table 6 Space Requirements
Allow a minimum of 15 cm (6”) of clearance at the rear of the ATD/
TD and 126 cm (4.5’) of clearance at the top of the ATD/TD/GC
system. If this is not possible, install the ATD/TD/GC system on a
bench that has wheels.
Dimensions: TD 43 cm (17”) wide x 48 cm
(19”) high x 34 cm (14”)
deep
ATD 43 cm (17”) wide x 48 cm
(19”) high x 56 cm (22”)
deep
AutoSystem XL
or Clarus 500
66 cm (26”) wide x 40 cm
(16”) high x 64 cm (25”)
deep
Weight: TD Approximately 25 kg
(55 lbs)
ATD Approximately 34 kg
(75 lbs)
AutoSystem XL
Clarus 500
49 kg (108 lbs.)
53.5 kg (118 lbs.)
CAUTION
Do not position the instrument so that it is difficult to remove
the appliance coupler from the rear panel to fully disconnect
the AC power.