User`s guide

Routine Maintenance
248
Figure 69 ATD Arm Housing
To gain access to the top of the heated valve, you must further
remove the transfer line cover.
8. Remove the two screws at the rear of the transfer line
enclosure (the upper, curved molding).
9. Slide the cover panel outward.
To replace the covers:
10. Replace the transfer line cover first. Secure the screws at
the rear of the enclosure.
11. Slide the arm housing back into place on the chassis.
Align the screw holes in the housing with those on the
chassis.
12. Replace the screw in the arm housing. Tighten down the
screws on the side panel.
13. Replace the carousel.
14. Reconnect the AC line cord.
Loosen Screw
(Do not remove the screw)
Remove Screw
Door Latch