User`s guide

Operation
124
Connect Tab
Key Clicks— If enabled, this option sounds a tone each time a
button is pressed, to confirm that you have pressed a key.
Baud Rate—Refer to the computer setup options to determine the
baud rate, as this value will depend on the computer. The ATD/TD
baud rate can be set from 300 to 57600 to match the computer’s
setting. The default setting is 9600.
NOTE: A baud rate of 9600 is required to allow use of the remote
Control Software (option).
Figure 33 Connect Tab
Handshake—Select the desired Handshake mode. Choose None,
Xon/Xoff, or hardware. Normally, you will use None.
Language—Select the language to be shown on the touch screen
display. Select the desired option from the drop down menu. Press
OK to confirm the selection and close the tab. The touch screen will
now be displayed in the selected language.
Brightness—Set the brightness so that the display is clearly visible
under all lab conditions.