User`s guide

Operation

To run a series of tubes using different methods, you can set up a

sequence. The sequence can be retained for routine use or it can be

edited as required.

NOTE: Multiple method operation must be enabled on the

Preferences tab. See the Preferences/Run tab section later

in this chapter.

1. Switch to the Run tab.

2. Select the Sequence button to enable the option. Press

the start tube entry box.

3. Press the plus or minus button to select the desired start

tube. Then enter the desired end tube.

4. From the method drop-down box, select the method to

be used for the selected range of tubes.

5. Press the Add button to add the entry to the sequence.

6. Repeat these steps until you have created the desired

sequence.

7. To delete an entry from the sequence, select the entry in

the list and press the Delete button. To change the tube

range, you must add a new entry with the revised tube

range and then delete the old entry.

NOTE: If you enter a tube range that has already been entered into

the sequence a warning message will be displayed.

8. If you edit the methods called by your sequence the

sequence will use the revised methods. If you need to

edit a method but do not want to affect your sequence,

then save the revised method with a different name.

You can use up to 8 methods in your sequence. If you

need to use more than 8 methods, you must use the

Remote Control Software (optional), in your PC.

9. Press the green Start button to run the sequence.

The TD or ATD will configure itself based on the first